<< Back Home Next in this Section >>

IAMCS Yeshiva Volunteer Instructions

Batteries for wireless microphone - installing and replacing

Written Instructions | Video (1:56)

Installing & Replacing Batteries for the Wireless Microphone

IMPORTANT: Change the batteries in both the transmitter and receiver every four hours, whether there is an indication of low battery (blinking power button) or not.

The following instructions work for both the transmitter (TX) and receiver (RX).

1. Orient the unit with its back facing you, and the top facing to your right.
2. On the back of the unit, with your left thumb, depress and hold the release button located beneath the Rodelink label plate.
3. While you are depressing the release button, give the entire back cover of the unit a push with your right thumb, and slide cover to the left.
4. Insert the batteries according to the diagrams inside the battery compartment. Flat side of the battery goes toward the spring.
5. Slide the cover closed.
6. IMPORTANT: When you replace the batteries, be careful to not yank the batteries out from the end of the battery that is touching the spring. Pull it out from its other end.